Parallel Line Tester Kit
Kit Number: 7195
An intuitive kit, simply place around an object and slide the bars together to check for parallel sides. If the bars both align with the pair of sides, then the sides are parallel. Accommodates shapes up to 7cm across and pairs great with our Basic Shapes Kits.
This kit is part of our K-5 Geometry Curriculum Track. Any/all of the lesson plans may pair this kit with any of the following kits:
- Angle Tester Kit
- Basic Shapes: Circles Kit
- Basic Shapes: Polygons Kit
- Basic Shapes: Quadrilaterals Kit
- Basic Shapes: Triangles Kit
- Partitioning Circles Kit
For more information on the curriculum track, refer to the downloadable "K-5 Geometry Curriculum Track Introduction" available in the curriculum section below.
Large Build Volume Prints Require Minimum Build Volume:
X: 124mm Y: 112mm Z (height): 15mm
Small Build Volume Prints Require Minimum Build Volume:
X: 111mm Y: 112mm Z: 15mm
Total Estimated Print Time*:
*Print times calculated on Dremel 3D40s and will vary between brands and models of printers. To see an accurate print time for your machine, wait until the build starts printing and then look at "Time Left" in the information box.